Medical Cap

From Machined and Stainless Caps to One Molded Part: About 80% Lower Cost

A medical equipment manufacturer was sourcing a threaded container cap two ways: machined from UHMW plastic and then dyed to color, or built as a stainless steel and plastic assembly from several components. Both were slow and expensive to make. FormRep replaced them with a single injection-molded polypropylene cap that costs about 80% less, comes out of the mold in the correct color, and paid back its tooling investment within a matter of months.

1 partMolded in one piece
~80%Lower cost
No dyeingColor molded in
MonthsTooling payback
  • Customer: Medical equipment manufacturer
  • Part: Threaded cap for a media container
  • Starting point: A cap machined from UHMW and dyed to color, or a multi-piece stainless steel and plastic assembly
  • Material: Injection-molded polypropylene (PP), molded in color
  • Results: About 80% lower cost, one part instead of several, shorter lead time, and tooling paid back within months

The challenge

Two versions of the cap were in use, and neither suited production. The UHMW version was machined from solid stock, a slow subtractive process, and then had to be dyed to the required color. The stainless steel version was over-engineered for the job: it used several components that had to be sourced and assembled, which added cost and lead time to every cap.

Original medical cap machined from UHMW plastic and dyed yellow
Before: cap machined from UHMW, then dyed to color.
Original medical cap built as a multi-piece stainless steel and plastic assembly
Before: stainless steel and plastic assembly made from several components.

One molded part, better than both

FormRep redesigned the cap as a single injection-molded polypropylene part and molded in the grip and venting that only the stainless version had, along with ribs for strength.

  • One piece, nothing to assemble. The molded cap replaces the stainless assembly and its components, which shortens lead time.
  • Color molded in. The polypropylene is colored as it is molded, so there is no dyeing step.
  • Ribs for strength. Molded ribs stiffen the cap while adding little material.
  • Knurled grip. Outer knurling makes the cap easier to screw on and off.
  • Vent hole for steady flow. A small vent relieves vacuum in the container as media is drawn out, so it flows more consistently.
One-piece injection-molded polypropylene medical cap with ribs, knurled grip and vent hole
After: one-piece molded polypropylene cap with ribs, knurled grip and vent hole.
The machined UHMW cap and stainless steel assembly alongside the new one-piece molded polypropylene cap
Both earlier versions (left and back) with the new molded cap (front right).

Results

Before After
Parts Machined cap, or a multi-piece stainless assembly 1 molded part
Material UHMW, or stainless steel and plastic Polypropylene (PP)
Color Dyed after machining Molded in
Assembly Required on the stainless version None
Grip and venting Included on the stainless version only Knurled grip and vent hole, molded into the part
Cost Baseline About 80% lower
Tooling payback n/a Within months

Why it matters

Machined parts and multi-piece assemblies are a sensible way to get the first parts made. Once demand is steady, a molded design can often do the same job in one part, cost far less and add features that would be expensive to machine. FormRep handles it start to finish: design, printed prototypes, tooling and injection molding, with no minimum run.

See more made-to-fit solutions, or read how a bolted acrylic tank lid became a two-piece molded lid.

Have a machined or assembled part that could be molded?
Request a quote →

Secret Link