Short answer 7/8″ connectors (often called mini-style) use a 7/8″-16UN threaded coupling and heavier contacts than M12. They carry power and fieldbus trunk lines, such as DeviceNet trunks and power distribution to I/O blocks. Match the pin count and gender, then check the current rating for your load.
What 7/8″ is for
When an M12 connector can’t carry the current a line needs, the next step up is 7/8″. The bigger body holds larger contacts and wire, so it is common for power feeds to distributed I/O, trunk lines on fieldbus networks and power to drives and valve banks. The coupling is a 7/8″-16UN screw thread. A few systems step up again to 1″-16UN for 6-pin power.
7/8″ at a glance
| Pins | Typical use | Typical ratings on our parts |
|---|---|---|
| 4 | DC power to I/O blocks and devices | 300 V, 8 A |
| 5 | Fieldbus trunk lines (power and data in one cable), power distribution | 300 V, 6 to 9 A depending on the part |
| 6 | Heavier power; also found on 1″-16UN connectors | 600 V, 13 A |
Ratings depend on the part, wire size and temperature. Check the data sheet for the exact part before you size a circuit.
How to pick a 7/8″ part
- Pin count. Match the port. A 4-pin and a 5-pin 7/8″ connector won’t mate.
- Male or female. Power usually comes from the female side so live pins aren’t exposed. Check the device.
- Current. Add up the loads on the line and stay under the rating of the connector and the wire.
- End of a trunk? Fieldbus trunks need a terminating resistor at each end. We list a 120 Ω 5-pin terminator.
Mistakes we see
- Running power through M12 cables because they fit. If the load needs more than M12 can carry, step up to 7/8″.
- Forgetting the terminator at the end of a trunk line. Missing termination causes intermittent network faults.
- Mixing up 7/8″-16UN and 1″-16UN. They look alike on a drawing but won’t thread together.
- Leaving unused ports open. Close them with a protective cap.
Shop 7/8″
- Cables: 4-pin female to female, 5-pin female cordset, open end, 5-pin Y-splitter to 7/8″ and M12, 6-pin to 1″-16UN
- Connectors: 5-pin female solder, 5-pin male solder, 5-pin panel-mount receptacle
- Accessories: terminating resistor, cap with chain
Browse them all under 7/8-Inch Cables, 7/8-Inch Connectors and 7/8-Inch Caps. Cables come in 1, 2, 5 or 10 m; other lengths, including lengths in feet, are built to order.
Common questions
Is 7/8″ the same as M12? No. 7/8″ is larger, uses an inch thread and carries more current. Adapter and Y cables can join the two.
Why do some 7/8″ cordsets mention M23? Some cordsets use a different coupling on one end to suit the device. The product page and data sheet show what each end is.
Can you build a 7/8″ cable that isn’t listed? Yes. Send the two ends, the pinout and the length for a quote.
Shop parts Part cross-reference Request a quote
DeviceNet is a trademark of its owner, used here for identification only.
