7/8″ Mini-Style Connector Guide: Pin Counts, Power and Fieldbus Trunks

Short answer 7/8″ connectors (often called mini-style) use a 7/8″-16UN threaded coupling and heavier contacts than M12. They carry power and fieldbus trunk lines, such as DeviceNet trunks and power distribution to I/O blocks. Match the pin count and gender, then check the current rating for your load.

What 7/8″ is for

When an M12 connector can’t carry the current a line needs, the next step up is 7/8″. The bigger body holds larger contacts and wire, so it is common for power feeds to distributed I/O, trunk lines on fieldbus networks and power to drives and valve banks. The coupling is a 7/8″-16UN screw thread. A few systems step up again to 1″-16UN for 6-pin power.

7/8″ at a glance

Pins Typical use Typical ratings on our parts
4 DC power to I/O blocks and devices 300 V, 8 A
5 Fieldbus trunk lines (power and data in one cable), power distribution 300 V, 6 to 9 A depending on the part
6 Heavier power; also found on 1″-16UN connectors 600 V, 13 A

Ratings depend on the part, wire size and temperature. Check the data sheet for the exact part before you size a circuit.

How to pick a 7/8″ part

  1. Pin count. Match the port. A 4-pin and a 5-pin 7/8″ connector won’t mate.
  2. Male or female. Power usually comes from the female side so live pins aren’t exposed. Check the device.
  3. Current. Add up the loads on the line and stay under the rating of the connector and the wire.
  4. End of a trunk? Fieldbus trunks need a terminating resistor at each end. We list a 120 Ω 5-pin terminator.

Mistakes we see

  1. Running power through M12 cables because they fit. If the load needs more than M12 can carry, step up to 7/8″.
  2. Forgetting the terminator at the end of a trunk line. Missing termination causes intermittent network faults.
  3. Mixing up 7/8″-16UN and 1″-16UN. They look alike on a drawing but won’t thread together.
  4. Leaving unused ports open. Close them with a protective cap.

Shop 7/8″

Browse them all under 7/8-Inch Cables, 7/8-Inch Connectors and 7/8-Inch Caps. Cables come in 1, 2, 5 or 10 m; other lengths, including lengths in feet, are built to order.

Common questions

Is 7/8″ the same as M12? No. 7/8″ is larger, uses an inch thread and carries more current. Adapter and Y cables can join the two.

Why do some 7/8″ cordsets mention M23? Some cordsets use a different coupling on one end to suit the device. The product page and data sheet show what each end is.

Can you build a 7/8″ cable that isn’t listed? Yes. Send the two ends, the pinout and the length for a quote.

DeviceNet is a trademark of its owner, used here for identification only.

Secret Link